D-Link DSL-302G User Manual page 60

To Add or Modify AAL5 Parameters define the following:
EOA Interface
Lower Interface
Conf. IP Address:
Net Mask:
Use DHCP:
Click the Submit button to save the settings in temporary memory. When you are done making changes to the
configuration settings, open the Commit & Reboot menu and click the Commit button to save your changes to
permanent memory.
DSL-302G ADSL Modem User's Guide
EOA Interface – Add
This is used (by the Modem) to identify the EOA interface.
If you are adding a new EOA interface, choose the EOA set you want
to define from the pull-down menu (Add menu only).
The name of the lower-level interfaces on which EoA interface will
operate. The low-level interface names are pre-configured in the
software and identify the type of traffic that can be supported, such as
data or voice. Internet data services typically use an AAL5-type
interface.
If you are adding a new VCC Interface, choose the AAL5 set you want
to define from the pull-down menu (Add menu only).
The IP address assigned to the interface. If the interface will be used
as a simple bridge to your ISP, then you do not need to specify IP
information. If you enable DHCP for this interface, then the Configured
IP address will serve only as a request to the DHCP server. The actual
address that is assigned by the ISP may differ if this address is not
available.
Some ISPs use static IP settings that are manually assigned to each
account. If your service provider instructs you to configure a Static IP
Address, type in the global IP Address for this EOA interface.
If you are assigned a Static IP Address and Net Mask, type in the Net
Mask for this EOA interface.
When checked, this setting instructs the device to accept IP information
assigned dynamically by your ISP's DHCP server. If the interface will
be used for bridging with your ISP, leave this checkbox unselected.
Select Enable or Disable for DHCP service.
42