Summary of Contents for D-Link DSL-302G - 8 Mbps DSL Modem
PC before installing the software. Thankyou for your purchase of the D-Link DSL-302G ADSL modem. This state of the art modem will deliver you flexible connectivity to your Internet Service Provider and allow you to connect to the Internet via your broadband ADSL connection.
1. INSTALLING THE MODEM 1.1. Software installation 1.1.1. Insert the DSL-302G CD-ROM into the CD-ROM drive. Within a few seconds you should see a dialog box as shown below. Click on Install DSL-302G. NB:- If the dialog box does not come up automatically, explore the CD (usually the D:\ drive) using Windows Explorer and double-click on the setup application file dsl302g.exe.
1.1.4. Click on Next to install the software into default location or click on Browse to select a different folder. 1.1.5. Select the software you wish to install. If you will be using a USB connection, you must install the USB driver.
1.1.6. Click on Next to use the default Program Folder as shown above or enter a different folder name. 1.1.7. Continue to follow the prompts in the Installation Wizard. Connect the power cable and click on Next...
If you are connecting to the modem using Ethernet cable, connect the Ethernet cable and click on Next If you are going to connect to the modem via USB cable, DO NOT connect the USB cable at this stage. You will need to connect the USB cable after finishing the software installation and rebooting the computer.
Connect the ADSL cable to the Modem and click on Next Click on Finish to complete the installation and restart your computer. 1.2. Connecting modem to PC If you have not done so, connect power cable to the modem. Switch it on. If you are going to connect to the modem via a network cable, connect the Ethernet cable to the modem.
If you are going to connect to the modem via USB cable, DO NOT connect the USB cable at this stage. You will need to connect the USB cable after finishing the software installation and rebooting the computer. * If you connected the USB cable before installing the driver please refer to paragraph 3.1.1. of the Troubleshooting section at the end of this guide.
2.2. Once you are logged into the modem you should see the Quick Configuration page. At the top of the screen you will see the Refresh Rate drop down menu. Select the No Refresh option. 2.3. Next, enter your connection details as per information gathered from your Internet Service Provider (see Table 1).
3. Troubleshooting 3.1. Troubleshooting DSL-302G driver installation: 3.1.1. If you are having trouble installing the DSL-302G modem: Note that when connecting to the DSL-302G modem via Ethernet port you do not have to install any drivers or software for the modem. You should be able to access the modem via your WEB browser straight away.
3.1.2. If you can not access DSL-302G modem via 10.1.1.1 or 10.1.1.2: 1. Check if the modem is powered on and make sure the Status light on the modem is flashing. 2. Try to reset the modem by pressing the reset button at the back of the unit 3 times. 3.
• Try specifying IP address and DNS settings on your computer as described above More information on DSL-302G can be found at http://www.dlink.com.au/products/broadband/dsl302g/ Technical support information on DSL-302G: http://www.dlink.com.au/tech/drivers/files/modems/dsl302g.htm D-Link Australia Technical Support can be contacted on 1300 766 868 or firstname.lastname@example.org...