Table of Contents
Advertisement
Activating automatic ECT (Explicit Call Transfer)
Step
by
With some ISDN systems, the original caller and the party called for enquiry
Step
purposes cannot be connected simply by hanging up.
In this case, you must activating this function.
Please refer also to the operating instructions for your PABX.
Press
1.
Select using [
2.
settings
Use [OK] to toggle between ON and OFF .
Info
If you activate this function, "Ext. enq. call" is automatically set (= in the central
office) (see page 26).
Reserving a line
You cannot make external calls when both external lines are being used by
other internal subscribers. In this case you can "reserve a line" . When an
external channel becomes available, the system calls you automatically and you
can make external calls again.
Reserving a line
You attempt to set up an external connection but all external lines are busy.
Press [CALLBCK].
1.
Accepting a free line
An external line becomes available. A recall is implemented.
Lift the handset: Press
1.
A connection is set up to the provider.
Set up the external connection as normal.
2.
Deleting a line reservation
An external line becomes available. A recall is implemented.
Press [DELETE].
1.
The external line reservation is deleted.
Dialling procedures
If your Gigaset 4070/4075isdnis connected behind a PABX, or the ISDN CO can
be controlled using the KEYPAD protocol, you can send commands to the
master PABX once the keypad function is activated.
Activating/deactivating automatic tone dialling
Automatic tone dialling is activated in the factory setting.
Press
1.
Select using [
2.
settings
menu item = ON / no = OFF).
The activated tone dialling is highlighted.
58
or *for selection menus.
] and [OK]:
Service Set up
o
Transition (ECT)
D
.
or *for selection menus.
Service Set up
] and [OK]:
o
o
Spec.function
or
Base Set up
'
(
before menu item = ON / no = OFF).
Base Set up
or
o
Dial properties
Auto Sw.to Tone
o
o
Settings
ISDN
o
o
Settings
System
'
(
before the
Advertisement
Table of Contents
