Table of Contents
Advertisement
If you have also entered a rate (see Section , "Entering the price per unit") the
Info
Step
call costs will be multiplied by this rate. You can also use a rate if you want to
by
bill for higher call costs, otherwise disable the rate (the cost display is to be
Step
increased by factor 2, for example).
Setting up "Units from CO"
for (Gigaset 3000 Comfort)
Press
1.
Select using [
2.
Costs
for (Gigaset 4000 Comfort)
Press * for the selection menus.
1.
Select using [
2.
3.
Enter the PIN and confirm with [OK].
4.
Select using [
Select using [
5.
If the item is marked, the units transmitted by the provider will be displayed or
used to calculate the costs. If the default setting "No Rate" is used, the units
will be displayed.
Entering the price per unit
Before the charges for each call can be calculated, the currency and price per
unit must be defined (the default setting is "No Rate"). For determining the
costs, "Units from CO" must be set (default).
for Gigaset 3000 Comfort
Press
1.
Select using [
2.
Costs
for Gigaset 4000 Comfort
Press * for the selection menus.
1.
Select using [
2.
Enter the PIN and confirm with [OK].
3.
Select using [
4.
Select using [
5.
Rate ----
Enter the basic price and confirm with [
6.
Select using [
7.
If you would like to set an additional currency:
Enter the currency and confirm [
8.
Select using [
9.
If [No Rate] was already set a prompt is displayed.
Confirm the prompt for accounting method with [YES].
10.
All accounts are reset and the option is highlighted.
44
for selection menus.
] and [OK]:
Service Set up
] and [OK]:
Costs
Access type
] and [OK]:
Units Centr.Off.
] and [OK]:
for selection menus.
] and [OK]:
Service Set up
] and [OK]:
Costs
] and [OK]:
Access type
] and [OK]:
Rate --.--
(without decimal point).
] and [OK]:
Save entry
] and [OK]:
Save entry
o
Settings
.
.
o
Settings
.
.
(with decimal point) or
9
].
.
9
].
.
o
o
System settings
o
o
System settings
Advertisement
Table of Contents
