Activating/Deactivating The Automatic Version Check; Activating Voip Status Message; Display - Siemens Gigaset S450 IP User Manual

Web configurator
Starting firmware update
Preconditions:
u
No calls are being made via the fixed
network or VoIP.
u
There is no internal connection
between the registered handsets.
u
The base station menu is not open in
any of the handsets.
¤
Click on
Update Firmware.
The firmware is updated. This process can
take up to 3 minutes.
Please note:
You can also start the firmware update on the
handset (page 66).
Activating/deactivating the
automatic version check
When the version check is activated, the
phone checks on a daily basis whether the
Siemens configuration server is carrying a
new version of the phone firmware or of
the file with the general settings for your
VoIP provider.
If a new version is available, a notification
is sent to the handset and the message key
flashes. You can then carry out an auto-
matic update of the firmware (page 66) or
of the VoIP provider settings (page 67).
¤
Open the following Web page:
¢
Settings Miscellaneous.
¤
Click on the option next to
Yes
matic check for software/profile updates
activate the automatic version check.
Click on if you do not want a version
No
check to be carried out.
¤
Click on Set to save the changes.

Activating VoIP status message

display

Display VoIP status messages on your
handset when there are VoIP connection
100
problems. These messages give you infor-
mation on the status of a connection and
contain a provider-specific code that helps
the service team when they are analysing
the problem.
¤
Open the following Web page:
Settings
¤
Click on the
status on handset
sage display
If you click on No, no VoIP status mes-
sages are displayed.
¤
Click on
Please note:
A table with possible status codes and their
meaning can be found in the Appendix on
page 105.
Auto-
to
¢
Miscellaneous.
Yes option after
to activate status mes-
Set to save the changes.
Show VoIP