Removing Optional Air Panel - Hitachi RPI-0.8FSG1 Service Manual

2.5.3 Removing Optional Air Panel

(1) Remove the electrical box cover by opening the air intake grille.
Disconnect the connector (CN17) for the auto-louver on the indoor PCB.
(2) Remove the air intake grille from the optional air panel.
Remove four (4) screws fixing the optional air panel.
(3) Remove the optional air panel after unhooking the hinge onto the hooks at the two positions near the
drain pan.
(Before Alteration)
Connector for Louver Motor
TURN OFF all power source switches.
PCB
2
PCN4
CN7
CN4
PCB
Tool Phillips Screwdriver
(After Alteration)
Connector for Louver Motor
TB
Optional Air Panel
Hinge
Screws
Screw x 2
(M6x30, Only for P-G46)
SERVICING
(2.5 2-Way Cassette Type)
PCB
2
(AC Chopper Model)
PCB
Hook
2-67