Remote Controller Operation; Installation Of Optional Air Panel: P-N23Na - Hitachi RCI-2.5-FSN3Ei Installation And Operation Manual

REMOTE CONTROLLER OPERATION

7 REMOTE CONTROLLER OPERATION
Refer to Instalation and Operations Manual attached to the
7.1 SETTING THE FILTER INDICATION INTERVAL
The FILTER interval indication on the remote control switch can be set a approximately 100, 1,200 or 2,500 hours (factory setting:
1,200 hours).
7.2 SETTING OF HIGH SPEED TAP
Ceiling height
1.0 to 2.5HP 3.0 to 6.0HP
Below 2.7m Below 3.2m
2.7 to 3.0m 3.2 to 3.6m
3.0 to 3.5m 3.6 to 4.2m

8 INSTALLATION OF OPTIONAL AIR PANEL: P-N23NA

8.1 FACTORY-SUPPLIED ACCESSORIES
!
C A U T I O N
When the air panel is unpacked, place it on insulation material, etc. to
protect the sealing insulation from scratches
Check to ensure that the following accessories are packed with
the air panel.
8.2 INSTALLATION

Location of suspension brackets
1 Check to ensure that the suspension brackets of the indoor
unit are located approximately 102mm higher the false
ceiling.

Removing air intake grille from air panel.
1 Open the air intake grille to an angle of approximately 45º
from the surface of the air panel as shown below.
Ceiling
Air panel
Wrong
2 Lift the grille keeping it inclined
3 Draw the grille towards the open space after lifting.
9 PMML0253A rev.5 - 08/2016
Setting of remote control switch
Standard
High Speed (1)
High Speed (2)
Take up the grille keeping it inclined
45º
Correct
Air filter Air intake grille
remote controller.
The air flow volume can be changed according to the ceiling
height by setting the item code to "C5" form the remote control
switch (Refer to the Installation & Maintenance Manual of the
remote control switch for details).
If any of these accessories are not packed in the packing,
please contact your contractor.
Accessory
Long screw (M6×50)

Installing air panel
a
Fixing nail
c
1 Remove the cover of the corner pocket (4 portions).
2 Pull the fixing nail towards the arrow mark according to the
order "a", "b" and "c".
3 The corner pocket can be lifted. After lifting, move it in "d"
direction, disconnect the L type hook and dismantle the
corner pocket.
4 Pull down theU-shaped hook (at 2 positions) located at the
indoor unit side.
Quantity Purpose
4 For fixing panel
Fixing nail
Fixing nail
b
d
L-Type hook