Hitachi RPI-0.8FSG1 Service Manual page 231

(5) Draw the fan leftward with lifting up the bearing side of the fan slightly, the fan and the fan motor are
removed.
(6) For attaching the fan motor and the fan, perform the reverse procedures for removing.
(7) Fix the fan at the position with 8mm clearance between the left end (bearing side) of the fan and the
partition plate.
(8) Fix the fan motor with the outlet of the lead wire at the position as shown below.
Bearing
TURN OFF all power source switches.
Lift up the fan and draw it leftward.
Loosen Screw
8mm
Fan
Partition Plate
Tool
Fan Motor
Tool
Fan Motor
SERVICING
(2.6 Wall Type)
Phillips Screwdriver
Phillips Screwdriver
Fan Motor
Lead Wire of Motor
o
60
2-91