Maintenance Group; Firmware Update - QUANTA STRATOS S210 Series S210-X12MS Technical Manual

I H
NSTALLING ARDWARE

Maintenance Group

This group of pages allows you to do maintenance tasks on the
device. The menu contains the following items:

Firmware Update


Preserve Configuration

Restore Factory Defaults

Figure 4-43. Maintenance Menu
Firmware Update
In MegaRAC GUI, this wizard takes you through the process of
firmware up gradation. A reset of the box will automatically fol-
low if the upgrade is completed or cancelled. An option to pre-
serve configuration will be presented. Enable it, if you wish to
preserve configured settings through the upgrade.
WARNING!
!
Please note that after entering update mode widgets, other web
pages and services will not work. All open widgets will be closed
automatically. If upgrade process is cancelled in the middle of the
wizard, the device will be reset.
Note:
The firmware upgrade process is a crucial operation. Make sure
that the chances of a power or connectivity loss are minimal when
performing this operation.
Once you enter into Update Mode and choose to cancel the
firmware flash operation, the MegaRAC
means that you must close the Internet browser and log back onto
®
the MegaRAC card before you can perform any other types of
operations.
To open Firmware Update page, click Maintenance > Firm-
ware Update from the main menu. A sample screenshot of
Firmware Update Page is shown in the screenshot below.
Figure 4-44. Firmware Update Page
Procedure:
Click Enter Update Mode to upgrade the current device firm-
ware. As below step by step:
4-56
M G
AINTENANCE ROUP
®
card must be reset. This