17) Setting X-Y Original Point
1. Please be sure to press the defensor safety switch before setting up the X-Y/rocking point of the
machine.
Caution
A. Setting X-shaft original point.
ⓐ Remove the surface cover of X-fixing frame.
ⓑ Move the upper feed plate to the center of X-shaft.
ⓒ As in the figure, loosen the clamp screw of X-sensor bracket and place X-sensor plate attached on the X-timing belt fixing
plate block at the center of the sensor. And then fasten fixing screw.
B. Setting Y-shaft original point.
ⓐ Move the upper feed plate to the center of Y-shaft.
ⓑ As in the figure, loosen the clamp screw of Y-sensor bracket and place X-sensor plate at the center of the sensor. And then
fasten clamp screw.
38
Clamp screw
Original point detection plate
Sensor
Clamp
screw
Original point detection plat
[ Fig.46 ]
Sensor
Clamp
screw
[ Fig. 47 ]