Analog Outputs - Ahlborn ALMEMO 2590-2 Operating Instructions Manual

Activation mode and relay contact status :
Relay variant 8 ´Driven externally´ permits manual activation via the keypad
or via the interface; (see Manual 6.10.10).
Relay variant 8:
For manual activation of relays press :
Trigger inputs
For the purpose of controlling the measuring se-
quence 2 trigger inputs are provided (keypad or
optocoupler). These are always present at ports
8 and 9.
The following trigger functions can be programmed as variants :
0: Start / stop a measuring operation
1: Once-only manual measuring point scan
2: Clear all maximum values and min values
3: Print measured value
4: Start / stop a measuring operation on level-controlled basis
8: Zero-set a measured value
-5: Execute macro 5
-6: Execute macro 6
-7: Execute macro 7
-8: Execute macro 8
-9: Execute macro 9

14.3 Analog outputs

V5 output modules
For the purposes of analog recording of measured
values it is still possible, at sockets A1 and / or A2
(2), to connect V5 output modules with an analog
output controlled by the device, e.g. recording ca-
ble ZA1601-RK (see Manual 5.1.1).
To select the socket press :
The following output modes can be programmed as variants :
0: Measured value of selected measuring channel :
2: Measured value of a programmed channel :
8: Programmed analog output (see below) :
The analog value appears below this in digits :
Relay-trigger modules
Status : active open
8: Driven externally
<ON> <OFF>
or
* OUTPUT MODULES
Socket : A2
Port: 28
Trigger: F1, Optocoupler
0: Start-Stop
Mªª MENU
0: Start - Stop
1: Once-only scan
2: Clear max and min values
3: Print
4: Start - Stop, Level-controlled
8: Zero-set meas. value
-5: Macro 5
-6: Macro 6
-7: Macro 7
-8: Macro 8
-9: Macro 9
* OUTPUT MODULES
Socket: A2
RK Recording cable
0: Select meas. channel
Analog value :
Mªª MENU
or
<P> : ▲
0: Selected meas channel
2: Assigned internally
8: Driven externally
Analog value :
ALMEMO ® 2590
*
ZA 8006 RTA3
P
*
M00
02234
P ©P
▼
M00
M01
08345
63