Once-Only Output / Saving Of All Measuring Points; Cyclic Output / Saving Of All Measuring Points - Ahlborn ALMEMO 2590-2 Operating Instructions Manual

11. Function menus

11.5.4 Once-only output / saving of all measuring points

Once-only manual measuring point scans for acquiring the current measured
values from all active measuring points (see Manual 6.5.1.1) can be initiated by
pressing <MANU>
(see 11.5.5, 11.5.8.3).
Once-only manual measuring point scan :
The following symbols will be displayed briefly as verification in the status bar
The start arrow will light up briefly and then go out again
Lights up when data is being output via the interface
Appears when measured values are saved
Each time the key is pressed again after this the measured values will be pro-
cessed with the associated measuring time.

11.5.5 Cyclic output / saving of all measuring points

For cyclic recording and output of measured values (see Manual 6.5.1.2) the
cycle and the output format must be programmed accordingly. The measuring
operation can be started by pressing
<STOP>
. Each time a measuring operation starts, if the device has been so
configured, the maximum, minimum, and average values of all measuring
points will be cleared (for standard setting see 13.8).
So long as no measuring operation has been started the
displays the cycle set. Once the function has been selected (see 8.4) the cycle
can be entered directly (see 8.5). Once started the timer counts down to the
next cycle.
Function
Cycle timer
Cycle (hh:mm:ss), Saving ON, List format
Switch memory activation ON / OFF by pressing :
The output format in which measured values are output via the interface can
be set by pressing
layouts see Manual 6.6.1)
Modify format by pressing
Format, adjacent columns ´n´:
To modify format
Format, table ´t´:
To start cyclic measuring point scan press
The following symbols will be displayed as verification in the status bar contin-
uously, i.e. so long as the measuring operation is running. (see 8.2) :
The start arrow lights up
Lights up when data is being output via the interface
Appears when measured values are saved
To stop cyclic measuring point scan :
40 ALMEMO
. The output format can be set in the function
:
or in function
<FORM>
® 2590
<START>
and stopped by pressing
cycle timer
Cycle timer :
Output format (see
<FORM>
Cycle timer: 00:02:00Sn
<FORM>
Cycle timer: 00:02:00St
<START>
<STOP>
Cycle timer
<MANU>
(s. 8.2) :
´ © ´
´ ´
COM
´ ´
REC
function
00:02:00 S
<MON/MOFF>
. 11.5.8.3). (Print
´ ´
©
´ ´
COM
´ ´
REC
´ ´
ll