Table of Contents
Advertisement
11. OUTPUTS
The following interfaces corresponding accessories or options either are neces-
sary. (see 14.2).
Interface
11.1
The ALMEMO
®
2490A version with the interface can not only be completely pro-
grammed via the computer thus enabling the user to read out all acquired data
(see Manual Ch 6) but also be networked together very easily thus enabling the
user to centrally acquire and record measured values from several measuring
instruments - even if these are located far apart (see Manual 5.3) . The data
cables required for this purpose (see Manual 5.2) are plugged into socket A1.
The baud rate for all data cables is is programmed on leaving the factory to 9600
baud; this setting should not be altered.
Analog outputs
11.2
An analog output cable ZA 1601-RK (0 to 2 V ) can be connected at socket(s)
A2 and / or A1 (3) without electrical isolation; (see Manual 5.1.1). In ´Device
configuration´ the functions ´ACH1 A2´ or ´ACH2 A1´ should now appear (see
Chapter 12); here the reference channels for the corresponding analog outputs
and the scaling requirements can be entered.
26
Advertisement
Table of Contents
