Table of Contents
Advertisement
1. Locate the dispenser indoors on a level counter top.
A.
LEG OPTION
Unpack the four (4) legs and install them into the threaded holes provided in the bottom of the unit.
The installer must provide flexibility in the product and utility supply to permit shifting the position of the
dispenser sufficiently to clean the area beneath it.
Note:
Before installing legs, remove the four (4) plastic thread plugs; push center in and remove the
plugs.
2. Utilities routing may be made through the rear of the cabinet by removing the plastic rear panel by the inlet
of the cold plate and removing the knock-out for the drain hose.
Optional routing through the bottom of the cabinet:
A.
Tip unit to the side to access the drain block, located behind the drip tray.
B.
Replace the straight fitting with 90° fitting that is in the drain kit supplied with the unit.
3. Beverage System: Connect the beverage system product lines as indicated on page 6. This work should be
done by a qualified service person. Note that the hoses are marked with numbers 1 through 4 or 6 ) for syr-
up connections.
4. Clean the hopper interior (see CLEANING INSTRUCTIONS on page 8).
5. Connect the power cord to a 120 volt, 60 cycle, 3-wire grounded receptacle. All electrical wiring must con-
form to national and local electrical codes.
91748
INSTALLATION INSTRUCTIONS
2
Hide quick links:
Advertisement
Table of Contents
