Dispenser; Cold Plate - Cornelius 2230 C4-100 Manual

DISPENSER

1. Clean the ice storage hopper at least once a month
2. Remove the center screw on the agitator disk and lift off the agitator and the agitator disk assembly. Wash
and rinse them thoroughly.
3. Wash down the inside of the hopper and top cover with a mild detergent solution and rinse thoroughly to re-
move all traces of detergent.
4. Replace the agitator.
5. Sanitize the inside of the hopper and agitator with a solution of 1/2 ounce of household bleach in 1 gallon of
water. (200 PPM)
6. Replace the agitator disk. Sanitize as described is Step 5. Be sure the center screw is replaced and the
screw is tight.
7. Remove Ice Chute Cover as follows:
A. Flex sides outward to disengage lower pins.
B. Lift Ice Chute cover to disengage upper pins.
C. Lower Ice Chute cover down out of unit. NOTE: It may be helpful to twist cover slightly.
8. Clean the inside of the Ice Chute and Ice Chute cover with a mild detergent solution and rinse thoroughly to
remove all traces of detergent.
9. Reverse steps above to reassemble Ice Chute.
10. Sanitize as described in Step 5.

COLD PLATE

1. Remove splash panel and merchandiser.
2. Remove bottom two (2) screws on the ice chute and loosen the top two (2) screws. You do not have to re-
move the ice chute. (During re-assembly, make sure the ice gate restrictor is relocated to its'correct position.
3. Remove the screws, hold the beverage faucet panel and bring forward.
4. Remove the tape holding the lower cold plate cover to the top cold plate cover.
5. Lift the lower cold plate cover up into the top cover.
6. Remove any debris from the drain trough and spring. Check that the drain hole is not clogged.
7. Wash down the inside of the cold plate, tray and cover with a mild detergent solution and rinse. A small, long
handled brush will be found helpful in reaching the corners.
8. Slide the cover forward, taking care that it is securely positioned on the cold plate.
9. Re-assemble.
9
91748