Table of Contents
Advertisement
1. *Locate the dispenser indoors on a level counter top, unpack 4 legs and install them into the threaded
holes provided in the bottom of the unit.
2. Connect 3/4"IPS (or equal) drain line to the 3/4"threaded drain connections at the lower rear of the unit.
This line must pitch downward to an open drain, and must contain no traps, or improper drainage will
result.
3. Clean the hopper interior (see cleaning instructions).
4. Connect the power cord to a 120 volt, 60 Hz. 3-wire grounded receptacle.
Unit is now ready for operation.
NOTE:
*Figure 1, page 6 provides mounting template for those who desire to mount dispensers on a
counter.
NOTE:
Water pipe connections and fixtures directly connected to a potable water supply shall be
sized, installed and maintained according to Federal, State, and Local Laws
OPERATING INSTRUCTIONS
Fill the hopper with ice and replace the lid. Pushing the dispense lever will cause ice to flow from the ice chute.
Ice flow will continue until the lever is released. If ice does not dispense, see the " Troubleshooting Guide"to fine
the cause
CAUTION: Use caution to avoid spilling ice when filling dispenser. Clean up immediately
and spilled ice from filling or operating the unit. To prevent contamination of ice, the lid
must be installed on the unit at all times.
CLEANING INSTRUCTIONS
WARNING: Disconnect power before cleaning. Do not use metal scrapers, sharp objects,
or abrasives on the surface of the liner as damage may result. Do not use solvents or other
cleaning agents, as they may attack the plastic liner.
Dispenser
1. Clean the ice dispenser interior at lease once a month.
2. Remove agitator assembly and wash and rinse it thoroughly.
3. Wash down the inside of hopper and top cover with mild detergent solution and rinse thoroughly to remove
all traces of detergent.
4. Replace agitator.
90665
INSTALLATION INSTRUCTIONS
OPERATOR INSTRUCTION
2
Advertisement
Table of Contents
