Quest BIB Option Installation Guide
INSTALLATION INSTRUCTIONS
NOTE: P/N 629097210 is used for Quest 4, w/o rear cabinet back panel, P/N 729011125 is used for
Quest 4, 4 hole BIB, P/N 729011126 is used for Quest 2, 2 hole BIB
1. Verify that the back panel of the unit has the 4-hole pattern, as shown in Figure 1.
NOTE: Does not apply to P/N 729011125 & 729011126 kits.
If the back panel cabinet has been updated with the 4-hole pattern proceed to Step 9, if not continue to
Step 2.
2. Remove the shelf from the top of the platform assemblies and slowly lift it out of the cabinet, as shown in
Figure 2. When the shelf is removed from the unit, remove the four rubber grommets from the shelf.
3. Install the rubber grommets removed in Step 2 into the new shelf, as shown in Figure 3.
Publication Number: 720901123INS
Figure 1.
Figure 2.
Figure 3.
- 2 -
4 holes on the
rear panel
© 2003-2014, Cornelius Inc.