Good Read Led Duration - Wasp WLS9600 Product Reference Manual

Good Read LED Duration

This feature specifies the amount of time that the Good Read LED remains on following a good
read. The good read LED on time can be set within a range of 10 milliseconds to 2,550
milliseconds (0.001 to 2.55 seconds) in 100ms increments.
Follow these instructions to set this feature:
1. Determine the desired setting in milliseconds. A setting of 0 means that the good read
2. Divide the desired setting by 10 (setting is in 100ms increments). Pad the result with lead-
3. Go to
4. Scan the barcode: SELECT GOOD READ LED DURATION SETTING.
5. Scan the appropriate three digits from the keypad in
6. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming
This completes the procedure. See
Table 41. Good Read LED Duration Setting Examples
STEP ACTION
1 Desired Setting
Divide by 10 (and pad with
2
leading zeroes)
3
4
Scan Three Characters From
5
Appendix D, Keypad
6
Product Reference Guide
LED stays on until the next time the trigger is pulled.
ing zeroes to yield three digits. For example: 0 = 000, 5 = 000, 20 = 020, etc.
page 72 and scan the ENTER/EXIT PROGRAMMING MODE barcode to enter
Programming Mode.
the duration which was determined in the steps above. You will hear a two-beep indica-
tion after the last character.
If you make a mistake before the last character, scan the CANCEL barcode to
abort and not save the entry string. You can then start again at the begin-
ning.
Mode.
Good Read LED
stays on until next
trigger pull (00)
000
Scan ENTER/EXIT PROGRAMMING MODE
Scan SELECT LABEL GONE TIMEOUT SETTING
'0' , '0' and '0'
Scan ENTER/EXIT PROGRAMMING MODE
Appendix D, Keypad
Table 41 for some examples of how to set this feature.
EXAMPLES
20ms
002
'0' , '0' and '2' '0' , '1' and '5'
Reading Parameters
representing
150ms 2550ms (2.55 sec.)
015 255
'2' , '5' and '5'
253