Scanning Features; Scan Mode - Wasp WLS9600 Product Reference Manual

References

Scanning Features

Scan Mode

This mode is associated with typical handheld reader operation. Selects the scan operating mode
for the reader. The following selections are valid for all models:
Trigger Single.
occurs:
- Scanning Active Time
- a label has been read
- the trigger is released
Trigger Hold Multiple.
the trigger is released or
scanning.
this mode.
Trigger Pulse Multiple.
Scanning Active Time
Read Timeout
Flashing.
by Flash On Time
Flash is OFF scanning is deactivated.
Always On.
trigger is pulled, the reader acts as if it is in Trigger Single Mode.
prevents undesired multiple reads of the same label while in this mode.
1. Controlled by
254
When the trigger is pulled, scanning is activated until one of the following
has elapsed
When the trigger is pulled, scanning starts and the product scans until
Scanning Active Time
Double Read Timeout prevents undesired multiple reads of the same label while in
When the trigger is pulled, continuous scanning is activated until
has elapsed or the trigger has been released and pulled again.
prevents undesired multiple reads of the same label while in this mode.
1
The reader flashes on and off regardless of the trigger status. Flash rate is controlled
and Flash Off Time. When Flash is ON the imager reads continuously; when
Flashing is the recommended scan mode for WLS9600 hands-free
(stand mode) of operation
No trigger pull is required to read a barcode. Scanning is continually on. If the
Flash On Time
.
has elapsed. Reading a label does not disable
Double Read Timeout
Double
WLS9600