About The Reader; Programming The Reader; Configuration Methods; Programming Barcodes - Wasp WLS9600 Product Reference Manual

About the Reader

Typically, units are factory-programmed for the most common terminal and communications
settings. If you need to modify any programmable settings, custom configuration can be
accomplished by scanning the programming barcodes within this guide.
The WLS9600 model has a Laser scan engine. Advancements in the LED technology used in
the imager-based readers significantly improve the illumination of the target field of view,
resulting in higher scan efficiency. Whether used in Single Trigger or Continuous Mode, the
ergonomic design of the reader will help to promote comfortable handling during extended
periods of use.
See "Interface Selection"on page 8
model type.

Programming the Reader

Configuration Methods

Programming Barcodes

The reader is factory-configured with a standard set of default features. After scanning the
interface barcode, you can select other options and customize your reader through use of the
instructions and programming barcode labels available in the corresponding features section for
your interface. Customizable settings for many features are found in "Configuration Using
Barcodes" starting on page 15.
Some programming labels, like
the single label to enact the change. Most, however, require the reader to be placed in
Programming Mode prior to scanning them. Scan an ENTER/EXIT barcode once to enter
Programming Mode. Once the reader is in Programming Mode, scan a number of parameter
settings before scanning the ENTER/EXIT barcode a second time, which will then accept your
changes, exit Programming Mode and return the reader to normal operation.
Product Reference Guide
for a listing and descriptions of available interface sets by
"Restore Custom Defaults"on page
There are some exceptions to the typical programming sequence described
above. Please read the description and setting instructions carefully when
configuring each programmable feature.
About the Reader
13, require only the scan of
3