Led And Beeper Indications - Wasp WLS9600 Quick Reference Manual

LED and Beeper Indications

LED and Beeper Indications
The reader's beeper sounds and its LED illuminates to indicate
various functions or errors on the reader. A "Green Spot" also
lights to indicate a good read. The tables below list these indica-
tions. One exception to the behaviors listed in the tables is that the
reader's functions are programmable, and may or may not be
turned on. For example, certain indications, such as the power-up
beep can be disabled using programming barcode labels. Reference
the PRG for a more detailed list.
Indication
Power-up
Good Read
ROM Failure
Limited Scanning
Label Read
Reader Disabled
14
LED
LED flashes/blinks on
power-up, however, this may
be too rapid to view. With a
USB interface, the LED blinks
until enumeration with the
host is completed.
LED behavior for this indica-
tion is configurable using the
PRG.
200ms on / 200ms off
N/A
The LED blinks continuously
100ms on / 900 ms off
Beeper
Reader beeps four times at
highest frequency and vol-
ume upon power-up.
One beep at current fre-
quency, volume,
mono/bi-tonal setting upon
a successful label scan.
Reader sounds one error
beep at highest volume for
200 mS.
Reader 'chirps' six times at
the highest frequency and
current volume.
N/A
WLS9600