Overheat Cut-Off Device - Baxi Solo 3 30 PF System Installation And Servicing Instructions

9.0 Overheat Cut-off Device - Page 35
Operation
1. The overheat cut-off device is of the manual reset type
the control should it ever operate.
NOTE: Cut-off is indicated by illumination of the
2. Hinge the lower door panel down (Fig 89).
3. - Turn the boiler thermostat control
knob fully anti-clockwise to the OFF position marked '0' (Fig.
, then turn the control knob clockwise
to the required thermostat setting. The red neon will go out
4. If the overheat cut-off operates repeatedly, refer to the
fault finding chart at the rear of this booklet and investigate