Baxi Solo 3 30 PF System Installation And Servicing Instructions page 24

6.0 Installation - Page 24
6.11 Method B
1. Remove the left or right hand air box blanking plate, as
appropriate, from the back plate air box by releasing the
three screws (Fig. 54).
2. Rotate the turret to face the selected opening (Fig. 53)
and remove the side blanking cap by pushing in and turning
anti-clockwise to release the bayonet fitting (Fig. 54).
3. Locate the swaged end of the flue duct over the bayonet
fitting on the turret, taking care not to damage the 'O' ring.
Lock the flue duct in place by pressing in and turning
clockwise (Fig. 55).
4. Engage the bayonet slots of the air duct over the location
lugs on the back plate opening and press and turn clockwise
to secure the air duct to the back plate (Fig. 56).
5. Engage the flue and air ducts into the hole previously cut
in the wall and through holes in other partitions (cupboards,
walls etc.).
6. Secure the back plate to the wall at the previously drilled
anchorage points with suitable screws. Before finally
tightening the screws, check that the assembly is level.
7. Take the flue terminal assembly and pass through the cut
hole from outside. Engage on the flue and air ducts. Slide
the flues together to the desired wall thickness. Tape the
sections together with the tape provided ensuring a good
seal is made (Fig. 57).
8. In order to increase security of the flue, the bayonet tags
may be deformed to secure the flue in position.
9. Make good between the wall and the air duct inside and
outside the building if the internal fitting kit has not been
used (Fig. 58).
10. The flue trim provided may be fitted if required, to neaten
up the make-up around the terminal (Fig. 59).
11. To fit the flue terminal trim:
a) The trim should be fitted once the flue is secure.
b) Take the three edge clips from the kit and fit to equi-
spaced onto the inner flange of the trim (Fig. 58a).
c) With the flanges towards the wall pass the trim over the
terminal, If required a bead of sealant may be applied to the
rear face of the trim.
d) Push firmly on the trim to ensure the edge clips engage
on the flue.