Connection Of The External Probe; Electrical Connections To Remote Control Device - Baxi Luna 3 Avant Series Instructions For The User And The Installer

25. CONNECTION OF THE EXTERNAL PROBE

GB
The boiler is prearranged for connection of an external probe (supplied as accessory).
HU
For the connection, refer to the fi gure below and the instructions supplied with the probe.
CZ
Figure 15
Kt curves
Graph 2

26. ELECTRICAL CONNECTIONS TO REMOTE CONTROL DEVICE

(SUPPLIED AS AN ACCESSORY)
The remote control device is not a standard
boiler component as it is su pplied as an
accessory. Open the electronic board and
connect the cable (supplied together with
the two-pin terminal board) to connector
CN7 on the electronic boiler board. Con-
nect the terminals of the remote control
device to the two-pin terminal board (fi gure
16).
925.492.2 BAXI - 925.200.1
When the external probe is connected, the heating
circuit temperature control device regulates the dis-
persal coeffi cient
Kt. To set the curves (0...90) press the +/-
tons.
NOTE: the maximum value of the fl ow temperature
TM depends on the F16 parameter setting (see sec-
tion 20). The
maximum fl ow temperature it may 85° or 45°C.
CN 5
Graph 3
INSTRUCTIONS PERTAINING TO THE INSTALLER
22
TM = flow temperature (°C)
T e = e x ternal temperature (°C)
CN 7
Figure. 16
but-