Table of Contents
Advertisement
er so that the
parts of the
>mitting . The
is 5 to 10 cm
r is vertical .
;ceiver with a
plume levels .
i volume op
reduce the
)utlet or to a
)nnection will
source that is
cnnection will
I not give any
ceiver will be
batteries. Be-
arge batteries
ly the battery
DO NOT
push the PTT when not actually desiring to trans-
mit.
Place unit in a secure place to avoid inadvertent use by chil-
dren .
DO NOT
operate the transceiver near unshielded electri-
cal blasting caps or in an explosive atmosphere .
AVOID
using or placing the transceiver in direct sunlight or
in areas with temperatures below -10°C (+14°F) or above
+60°C (+140°F) .
The use of non-Icom battery packs/chargers may impair
transceiver performance and invalidate the warranty.
Even when the transceiver power is OFF, a slight current still
flows in the circuits . Remove the battery pack or case from
the transceiver when not using it for a long time . Otherwise,
the battery pack or installed Ni-Cd batteries will become ex-
hausted.
For USA only.
Caution : Changes or modifications to this transceiver, not ex-
pressly approved by Icom Inc., could void your authority to
operate this transceiver under FCC regulations .
SUPPLIED ACCESSORIES
Accessories included with the transceiver :
O Antenna . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
OO
Belt clip . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
Os Battery case (BP-194)
with 8 Ni-Cd (AA) batteries* installed . . . . . . . . . . . . . . . 1
® Wall charger* . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
*Not supplied with some versions .
Advertisement
Table of Contents
