Icom IC-T2H Instruction Manual page 18

BASIC OPERATION
" Notes for "Set mode"
The following items can be set from VFO mode.
Set mode items:
Tuning steps (p . 14)
Duplex setting (p . 15)
Repeater tones (p . 16)
Offset frequency (p . 16)
Subaudible tones (p . 16)
Call channel (p . 20)
CTCSS tones (p . 26)
When setting items from memory mode, input data will dis-
appear when changing memories or turning power OFF.
Please select VFO mode before entering set mode, and read
the instructions for each set mode item carefully.
To turn set mode ON and
OFF :
D Push
[A
V] or [*(CALL)]* for 1 sec. to enter set mode .
OO
Push [
4 ]
one or more times to select the item .
O Push the [A/V] keys to select the desired value.
® Push
[A
V] or
[0
(CALL)]* to exit set mode .
" Setting tuning
steps
The transceiver has 8 tuning steps as follows:
5 kHz 10 kHz 12 .5 kHz 15 kHz
20 kHz 25 kHz 30 kHz 50 kHz
11
1111
i_' _7
C
1,1111
kHz is
selected .
quency intervals of repeaters in your area .
USING SET MODE
O Push
[A
V] or [* (CALL)]* for 1 sec. to enter set mode .
OO
Push [4] one or more times to select the tuning step item .
O Push the [A/V] keys to select the desired tuning step .
® Push the same key used in step D above to enter the tun-
ing step and exit set mode .
This display shows that a tuning step of
25
For convenience, select a tuning step that matches the fre-
"9WNOTE:
Selecting a tuning step is possible using one of the pro-
grammable key/switches when this function is assigned
using key customize mode (p . 31). In this case, pushing
[a (tS)] enters tuning step mode .
When pushing [ , ] to exit set mode, any changes made
while in set mode are cancelled.
" Genei
When using a
the receive fre(
to program rel
19) .
T Set the rece
© Push [DUP]
" °-DUP" indii
indicates the
-When the at
selection an
Oa Push [c T]
cording to n
" °T' appears
" Refer to the
page .
® Push and h
-The display
frequency (i
" If °oFF" app
05 Release [P'
© Push and r
transmit sic