Table of Contents
Advertisement
iter, the transmit fre-
Iuency by an amount
111 II
i_i
i_I
11
.L-10-0
Offset frequency of
160 MHz is selected .
et frequency and exit
ry mode :
" Auto repeater
USING
INITIAL SET MODE
function
(USA version only)
The USA version automatically activates the repeater settings
(duplex, ON/OFF, duplex direction, tone encoder ON/OFF)
when the operating frequency falls within or outside of the
general repeater output frequency range. The offset and re-
peater tone frequencies are not changed by the auto repeater
function, reset these frequencies, if necessary.
D While pushing [8] + [0], turn power on to enter initial set
mode .
02 Push [ 4 ] one or more times until "AR" appears.
Os Push ["]/[V] to select the desired condition.
" "oFF-the auto repeater function is
turned off;
"oni "-the auto repeater function acti-
vates for duplex only ;
"on2"-the auto repeater function acti-
vates for duplex and tone .
Ml
i
-
i
1
iiii
1111 1
® Turn power off, then on again to exit initial set mode .
Frequency range and offset direction
REPEATER OPERATION r J
FREQUENCY' RANGE
DUPLEX DIRECTION
145.200-145 .495 MHz
°-DUP" appears
146.610-146 .995 MHz
147 .000-147 .395 MHz
"DUP" appears
Advertisement
Table of Contents
