Memory (Skip) Scan - Icom IC-T2H Instruction Manual

Programmed scan repeatedly scans between two user-pro-
grammed frequencies (memory channels "PA" and "Pb"). This
scan is useful for checking for signals within a specific fre-
quency range such as repeater output frequencies, etc.
O Push
[A
V] to select VFO mode, if necessary.
OO
Push [SC] to start the scan .
" To change the scan direction, push ["] or ["].
Os Push [SC] again to stop the scan .
NOTE : Scan edges, PA/Pb, must be programmed in ad-
vance (program them in the same manner as regular
0
memory channels-p . 19).
If the same frequencies are programmed
edges, programmed scan will not proceed.
into the scan
" Memory (skip) scan
SCAN OPERATION
H
Memory scan repeatedly scans all programmed
channels, except those set as skip channels .
O Push
[A
V] to select memory mode, if necessary.
" "m"
appears.
OO
Push [SC] to start the scan .
" To change the scan direction, push ["] or ["].
Os Push [SC] again to stop the scan .
O Setting skip channels
In order to speed up the scan interval, you can
channels you don't wish to scan as skip channels .
O Push
[A
V] to select memory mode, if necessary.
" "m"
appears.
O Push ["y[V] to select a memory channel to set as
channel.
O Push [SC] for 1 sec. to toggle the
skip setting on/off .
" "SKIP"
appears when the channels is
set as a skip channel.
" If memory scan is accidentally started,
push [SC] to stop it.
memory
set memory
a skip
m
, 11 111111
11111.1111
SKIP
Memory channel 10 is
set as a skip channel.