Download  Print this page

Chapter 1 - Getting Started; About This Manual; Unpacking Your Device; Charging The Scanner Battery - Honeywell Voyager 1602g User Manual

Hide thumbs


Getting Started

About This Manual

This User's Guide provides installation and programming instructions for the Voyager 1602g scanners. Product specifications,
dimensions, warranty, and customer support information are also included.
Note: The selections in this User's Guide are dependent on the Voyager 1602g model you have purchased. PDF and 2
dimensional bar codes can only be read by model 1602g2D and cannot be read by model 1602g1D.
Honeywell bar code scanners are factory programmed for the most common terminal and communications settings. If you need
to change these settings, programming is accomplished by scanning the bar codes in this guide.
An asterisk (*) next to an option indicates the default setting.

Unpacking Your Device

After you open the shipping carton containing the product, take the following steps:
• Check for damage during shipment. Report damage immediately to the carrier who delivered the carton.
• Make sure the items in the carton match your order.
• Save the shipping container for later storage or shipping.

Charging the Scanner Battery

The scanner's battery must be fully charged before the first use. It can be charged using a power supply or by connecting the
USB cable to a computer. Refer to

Charging with a Power Supply

Connect the mini-USB connector to the scanner. Assemble the wall plug. Attach the plug to the USB connector, then plug
into an electrical outlet, as shown below.
About the Battery
on page 3-5 for further battery information.
1 - 1

Hide quick links:


Table of Contents

  Also See for Honeywell Voyager 1602g

  Related Manuals for Honeywell Voyager 1602g