Sartorius FC06BBE-S Operating Instructions Manual page 67

Practical Example
When weighing in formulation components, the second component is over-poured.
Settings (changes in the factory settings required for this example):
Setup: Application parameters: Application 1: Recalculation
Step
1. Delete previously stored values,
if necessary
2. Place container for filling
components on the scale
3. Tare
4. Add the first component
5. Store component
6. Add the second component
7. Start recalculation, because
10.73 g were poured rather
than 10.60 g
8. Either press the minus
key to correct the value ...
Key (or instruction)
c
Place empty container
on the scale
t
Weigh the first component
into the container
Comp.1
Press the
Weigh the second
component into the container
Recalc
soft key
Minus
soft key repeatedly
Display/Output
Comp1 + 25.08 g
67