Sartorius FC06BBE-S Operating Instructions Manual page 12

12
Getting Started
Connecting the Scale to AC Power
§ Check the voltage rating and the plug design
– If they do not match, contact your Sartorius office or dealer
Use only:
– Original Sartorius AC adapters
– Power supplies approved by a certified or authorized technician
$ To use a main feeder cable from the ceiling or a CEE plug, have this equipment installed
or mounted by an authorized technician in your facilities
$ To use an external rechargeable battery pack, see "Accessories" in the "Overview" section
§ Insert the right-angle plug into the jack and use a screwdriver to tighten the
slotted-head screw
§ To energize the scale with AC power:
Plug the AC adapter into a wall outlet (mains)
Information on Radio Frequency Interference
Note:
This equipment has been tested and found to comply with the limits pursuant to part 15
of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with these instructions, may cause
harmful interference to radio communications.
For information on the specific limits and class of this equipment, please refer to the
Declaration of Conformity. Depending on the particular class, you are either required or
requested to correct the interference.
If you have a Class A digital device, you need to comply with the FCC statement as
follows: "Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his
own expense."
If you have a Class B digital device, please read and follow the FCC information given
below:
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the receiv-
er is connected.
– Consult the dealer or an experienced radio/TV technician for help.
Before you operate this equipment, check which FCC class (Class A or Class B) it has
according to the Declaration of Conformity included. Be sure to observe the information
of this Declaration.
Safety Precautions
The AC adapter rated to Class 2 can be plugged into any wall outlet without requiring
any additional safety precautions. The ground or earth terminal is connected to the
scale housing, which can be additionally grounded, if required. The data interface is
also electrically connected to the scale housing (ground).
Connecting Electronic Peripheral Devices
§ Make absolutely sure to unplug the scale from AC power before you connect or
disconnect a peripheral device (printer or PC) to or from the interface port
Warmup Time
To deliver exact results, the scale must warm up for at least 30 minutes after initial
connection to AC power or after a relatively long power outage. Only after this time
will the scale have reached the required operating temperature.
Using Verified Scales as Legal Measuring Instruments in the EU*:
$ Make sure to allow the scale to warm up for at least 24 hours after initial connection
to AC power or after a relatively long power outage
* including the Signatories of the Agreement on the European Economic Area