Interface Description - Sartorius FC06BBE-S Operating Instructions Manual

Factory series fc and fcg models electronic precision scales
Hide thumbs Also See for FC06BBE-S:
Table of Contents

Advertisement

Interface Description

Purpose
Your Factory scale comes equipped with
an interface port for connection to a
computer or other peripheral device.
You can use an on-line computer to
change, start and/or monitor the func-
tions of the scale and the application
programs. The interface port also has
four data output port lines for the
over/under checkweighing program.
A connector for a hand or foot switch
is also provided.
!
Warning When Using Pre-wired
RS-232 Connecting Cables!
RS-232 cables purchased from other
manufacturers often have incorrect
pin assignments for use with Sartorius
scales. Be sure to check the pin assign-
ment against the chart below before
connecting the cable, and disconnect
any lines marked "Internally Connected"
(e.g., pin 6). Failure to do so may
damage or even completely ruin your
scale and/or peripheral device.
108
Available Features
Type of interface:
Operating mode:
Standard:
Transmission rates:
Parity:
Character format:
Handshake:
(CTS/DTR)
Operating mode:
Network address**:
Data output format of the scale:
* XBPI operating mode: 9,600 baud, 8 bits, odd parity, 1 stop bit
** Network address is valid only in the XBPI mode
Factory Settings:
Transmission rate:
Parity:
Stop bits:
Handshake:
Operating mode:
Network address:
Print manually/automatically:
Stop automatic printing:
Automatic printout,
time-dependent:
Tare after ind. printout:
Application initialization values:
Line format:
Preparation
§ See the page 113 for the pin assignment chart
Serial interface
Full duplex
RS-232
150; 300; 600; 1,200; 2,400; 4,800; 9,600;
19,200 baud
Space, odd, even
1 start bit, 7- or 8-bit ASCII, parity, 1 or 2 stop bits
2-wire interface: via software (XON/XOFF);
4-wire interface: via hardware handshake lines
(CTS/DTR)
SBI, XBPI*
0, 1, 2, ..., 30, 31
16 or 22 characters
1,200 baud
Odd
1 stop bit
Hardware
1 character after CTS
SBI
0
Manual after stability
Not possible
After 1 display update
Off
Off
For other applications/GLP
(22 characters)

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents