Assembly - Fire Sense PH01-S XL Series Instruction Manual

Step 15: Secure the bottom of the LP Tank/Cylinder to the Base of the Heater
Hardware Used: None
Place the LP Tank/Cylinder onto the base of the heater and secure the Base to the Tank by evenly tightening the
3) M8x25 Bolts (I) which were originally preassembled to the 3 LPG Cylinder Brackets (H) which were thereafter
assembled to the inside floor of the base during Step #2. Once the bolts are secured against the base rim of the
Tank, lower the Tank Housing.
Caution: It is important to secure the cylinder tank to the heater base to ensure that the tank is not dislodged
if accidentally tipped over during severe weather or while being moved.
A minimum supply pressure of .5 psi is required for the purpose of input adjustment of propane gas. Storage of
an appliance indoors is permissible only if the cylinder is disconnected and removed from the appliance. A
cylinder must be stored outdoors in a well-ventilated area out of the reach of children. A disconnected cylinder
must have dust caps tightly installed and must not be stored in a building, garage, or any other enclosed area.
The minimum permissible gas supply pressure of 11 W.C. is required for purpose of hose adjustment. The
minimum hourly of 17,500 BTU is required input rating for a heater for automatic operation rating less than full
input rating.
The pressure regulator and hose assembly supplied with the appliance must be used.
The installation must conform with local codes, or in the absence of local codes, with national fuel gas code, ANSI
Z223.1/NFPA54, natural gas and propane Installation Code, CSA B149.1, or propane storage and handling code,
B149.2
A dented rusted or damaged propane cylinder may be hazardous and should be checked by your local cylinder
supplier. Never use a propane cylinder with a damaged valve connection.
The propane cylinder must be constructed and marked in accordance with the specifications for LP gas cylinders
of the U.S. Department of Transportation (DOT) or the standard for cylinders, spheres and tubes for
transportation of dangerous goods and commission, CAN/CSA-B339.
The cylinder must have a listed overfilling prevention device.
The cylinder must have a connection device compatible with the connection for the appliance.
The cylinder used must include a collar to protect the cylinder valve.
Never connect an unregulated propane cylinder to the heater.
 Do not store a spare LP-gas cylinder under or near this appliance.
 Never fill the cylinder beyond 80 percent full.
 Place the dust cap on the cylinder valve outlet whenever the cylinder
is not in use. Only install the type of dust cap on the cylinder valve
that is provided with the cylinder valve. Other types of caps or
plugs may result in leakage of propane.

ASSEMBLY

OPERATING INSTRUCTIONS
16