Pc Connection / Tipkom Pc Connection / Tipkom; Installation - TIPTEL 192 Operating Instructions Manual

Remote control (only tiptel 193)
Remote control settings (continued)
Remote erase:
8. When pressing the
the display switches between on and
off.
Remote pre-interrogation free of charge:
8. When pressing the
the display switches between on and
off.
9. Press the
PC connection / TipKom
PC connection / TipKom
The software "TipKom for Windows" from the scope of supply enhances the functional scope of
your tiptel 192/193, e. g. by the options:
m Loading and saving the call number memory
m Loading and saving the voice memory (only tiptel 193)
m Call data management
m Change of settings and others
m Dialling
m Loading a new operating software. You will always find the latest operating software version
and the latest PC software and TAPI driver in the Internet under www.tiptel.de.

Installation

m Connect your tiptel 192/193 to any serial interface of your PC. Should you only have a free
25-pin port free at your PC, you can use a customary adapter (9 pin <> 25 pin).
m Insert the TipKom disk and start the "SETUP" program. Then, just follow the given instruc-
tions.
or button,
or button,
button.
Your selection is shown in the display.
on: Recorded incoming messages can be
erased during a remote interrogation.
off: Recorded incoming messages cannot
be erased during a remote interrogation.
Your selection is shown in the display.
on: If new messages have been recorded,
the device picks up after the delay pro-
grammed within the menu "answering
machine set-up". If no new messages
have been recorded, there will be an
additional delay of 10 seconds before
the answering machine picks up. In
this way, you can replace the handset
and save telephone charges.
off: The device always considers the delay
programmed under "call delay"
The setting is stored.
59