Sony DSC-T1 Cyber-Shot Operating Instructions Manual page 94

Your computer does not
recognize your camera.
You cannot copy images.
After making a usa
connection, "Image
Transfer" does not
automatically start.
The image cannot be
played back on a
computer.
94
,
Cause
.
.
The camera is turned off.
.
The battery level is low. .
You are not using the supplied USB cable. .
The USB cable is not connected firmly.
.
The camera is not properly installed to the USB
cradle.
.
[USB Connect] is set to [PTP] on the Setup
screen.
.
The USB connectors on your computer are
connected to other equipment besides the
keyboard, the mouse and the USB cradle.
.
The camera is not connected directly to your
computer.
.
The USB driver is not installed.
.
Your computer does not properly recognize the
device because you connected the camera and
your computer with the USB cable before you
installed the "USB Driver" from the CD-ROM
(supplied).
.
The camera is not correctly connected to your
computer.
.
You are not using the correct copy procedure for
your OS.
-
-
-
-
-
-
ii:
i'
~ Turn ou the camera (page 16).
~ Use the AC Adaptor (page 15).
~ Use the supplied USB cable (page 79).
~ Disconnect the USB cable from both the computer and the USB
cradle, and connect it again firmly. Make sure that "USB Mode"
is displayed on the LCD screen (page 79).
~ Properly install the camera (page 10).
~ Set it to [Normal] (pages 44 and
107).
~ Disconnect all equipment other than the keyboard, the mouse
and the USB cradle from the USB connectors.
~ Connect the camera directly to your computer without passing
through a USB hub or other device.
~ Install the USB driver (page 76). ,
~ Delete the incorrectly recognized device from your computer
(page 82), then install the USB driver (page 76).
~ Connect the camera and your computer correctly using the USB
cable (page 79).
~ Follow the designated copy procedure for your OS (pages
81,82
and 86).
~ If you use the "Image Transfer" software, see page 80.
~ If you are using the "ImageMixer Ver. 1.5 for Sony" application
software, click on HELP.
~ Select [Launch Image Transfer automatically when your
camera, etc., is connected.] at [Basic] setting (page 81).
~ Make a USB connection when the computer is turned on
(page 79).
~ If you are using the "ImageMixer Ver. 1.5 for Sony" application
software, click on HELP.
~ Consult the computer or software manufacturer.