Sony DSC-T1 Cyber-Shot Operating Instructions Manual page 124

SONY
Quick Start Guide tor connection to your
computer
Follow these instructions to transfer images from your camera to your computer.
These instructions depend on your computer environment, so be sure to follow the instructions
which relate to your situation.
This Quick Start Guide shows only the basic steps for connection. Refer to your digital still
camera's Operating Instructions for further details or visit www.sony.com/support.
o
Choose your Computer
Environment and Perform Setup
Be certain to choose your OS and follow
these instructions carefully in order to
insure proper operation.
Microsoft@ Windows XP Home Edition/
Professional
There is no need to install a driver.
Microsoft@ Windows 98/98SE/Millenium
Edition (Me)/2000 Professional
Do not connect your camera to your
computer until the USB driver is installed.
1 Start up your computer and insert the
supplied
CD-ROM
in the CD-ROM drive.
2 Click [Cyber-shot] on the model selection
screen.
3
Click [USE Driver] on the title screen.
4
Click [Next]. When the "Information"
screen appears, click [Next]. The USE
Driver installation starts. When the
installation is completed, the screen inform
you of completion.
5
Click [Yes, I want to restart my computer
now] and click [Finish]. Your computer
restarts, and is ready for USB connection.
Macintosh@ OS 9.1/9.2, OS X (v10.0/
vi O.1/v1 0.2)
There is no need to install a driver.
@ 2003
Sony Corporation Printed in Japan
e
Connect your Camera to your
Computer with the USB Cable
When connecting your camera to your
computer, be sure to use a fully charged battery
pack, batteries or an AC Adaptor if available.
Insert the recording medium. .
Refer to the Operating Instructions of your
camera for recording medium that can be used
with your camera.
2 Turn
on the computer.
3
Turn on the camera, then connect the USE
cable to the camera.
.
If a USB cradle is supplied with your camera,
just connect the USB cable to the USB cradle,
and do not turn on the camera in this step. Turn
on the camera when you mount the camera in
the USB cradle after performing step 4.
4
Connect
the USE cable to the computer.
5 "USB Mode" appears on the screen.
USB Mode
Normal
0000
Switch on ~
*
This message appears only on models that
conform to the PictBridge standard.
3-088-014-11
(1)