Sony DSC-T1 Cyber-Shot Operating Instructions Manual page 89

The battery
remaining
indicator is incorrect, or
sufficient battery
remaining indicator is
displayed but the power
runs out soon.
The battery pack runs
down
too quickly.
You cannot turn on the
camera.
The power turns off
suddenly.
.
You have used the camera for a long time in an
extremely hot or an extremely cold location.
.
A deviation has occurred in the remaining
battery time.
.
The battery pack is discharged.
.
The battery pack is dead (page III).
.
You are shooting/viewing images in an
extremely
cold location.
.
The battery terminal is dirty.
.
The battery pack is dead (page III).
.
The battery pack is not installed correctly.
.
The AC Adaptor is disconnected.
.
The AC Adaptor has malfunctioned.
.
The battery pack is discharged.
.
The battery pack is dead (page Ill).
.
The camera is not properly installed to the USB
cradle.
.
If you do not operate the camera for about three
minutes when using a battery pack, the camera
turns off automatically to prevent wearing down
I
the battery (page 16). .
The battery pack is discharged.
.
The camera is not properly installed to the USB
cradle.
Shooting still images/movies
The LCD screen is not
turned on even when the
power is turned on.
The subject is not visible
on the LCD screen.
~ See page 11 L
~ Fully discharge and then charge the battery pack so that the
battery remaining indicator functions correctly (page 13).
~ Install a charged battery pack (page II).
~ Replace the battery pack with a ncw one.
~ Clean the battery terminal with a cotton swab, etc., and
charge
the battery
pack.
~ Replace the battery pack with a new one.
~ Install the battery pack correcOy (page I I).
~ Properly connect the AC Adaptor (page 15).
~ Consult your Sony dealer
or local authorized Sony service
facility.
~ Install a charged battery pack (page 11).
~ Replace the battery pack with a new one.
~ Properly install the camera (page 10).
~ Turn on the camera again (page 16) or use the AC Adaptor
(page IS).
~ Install a charged battery pack (page I I).
~ Properly install the camera (page 10).
Solution
.
The LCD backlight is turned off with
101
in the ~ Turn on the LCD backlight with
101
(page 25).
dark place.
.
The mode switch is not set to
0
or
I ~ Set it to
0 or
tQ~ (pages 22 and 70).
i
J
::;t
o
<::
0-
e;;-
rn
::r
o
~
S.
<Q
II~
89