Turning On/Off Your Camera; How To Use The Control Button - Sony DSC-T1 Cyber-Shot Operating Instructions Manual

Turning on/off your camera
.. Slide the lens cover in the
direction of arrow or press the
POWER button.
The POWER lamp (green) lights up and the
power is on. When you turn on your camera
for the first time, the Clock Set screen
appears (page
17).
Turning off the power
Slide the lens cover in the opposite direction
of the arrow or press the POWER button
again. The POWER lamp goes out, and the
camera turns off.
.
If you open the lens cover too quickly, the
camera might not turn on. If this happens, close
the cover
and then open
it again more slowly.
.
When opening the lens cover, be careful
not to touch the lens.
16
Auto power-off function
If you do not operate the camera for about
three minutes during shooting
or when performing the Setup,
camera turns off automatically
wearing down the battery. uto
power-off function only op when
the camera is operating using a battery
pack. The auto power-off function also
will not operate in the following
circumstances.
.
When
.
ng movies
.
Wh ying back a slide show
.
When a connector is plugged into the
of
(USB) jack or the AN OUT
(MONO) jack with the camera
connected to the USB cradle
How to use the
control button
C>
~
FINE
"
~:!; PFX I>
To change the current settings of the
camera, bring up the menu or the Setup
screen (page 44), and use the control button
to make the changes.
For each item, press JJ..JT/"'/~ to select the
desired value, then press. or JJ..JT/.../~ to
make the setting.