Using Your Camera Abroad - Sony DSC-T1 Cyber-Shot Operating Instructions Manual

Using the AC Adaptor
Multi connector
AC Adaptor
D
... Connect the AC Adaptor
(supplied) to the multi
connector of the camera.
When placing the camera, make sure the
LCD screen is facing up.
Connect the plug with the'"
mark facing
up.
.
Connect the AC Adaptor to an easily accessible
wall outlet (wall socket) close by. If any trouble
occurs while using the adaptor, immediately
shut off the power by disconnecting the plug
from the wal1 outlet (wal1 socket).
@ To wall outlet
(wall socket)
fJ
... Connect the power cord (mains
lead) to the AC Adaptor and
then to a wall outlet (wall
socket).
.
After using the AC Adaptor, disconnect it both
from the multi connector of the camera and
from a wal1 outlet (wall socket).
.
The set is not disconnected from the AC power
source (mains) as long as it is connected to the
wall outlet (wall socket) even ifthe set itself has
been turned off.
Using your camera
abroad
Power sources
You can use your camera in any country or
region with the AC Adaptor (supplied)
within 100 V to 240 V AC, 50/60 Hz. Use a
commercially available AC plug adaptor
[a], if necessary, depending on the design of
the wall outlet (wall socket) [b].
AC-LM5 ~~~~Q
[a] [b]
.
Do not use an electronic transfonner (travel
converter), as this may cause a malfunction.
-
( ;')
<II
~
.g"
II>
0;
i}
Q,
15