Sony DSC-T1 Cyber-Shot Operating Instructions Manual page 2

To prevent fire or shock hazard, do
not expose the unit to rain or
moisture.
For the Customers in the U.S.A.
~
l
e'''oe'mcm:'~o''
l
;f\
L1.i
DO NOT OPEN
~
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK)
NO USER_SERVICEABLE PARTS INSIDE
REFER SERVICING TO QUALIFIED SERVICE
PERSONNEL
&
This symbol is intended to alert
~
the user to the presence of
uninsulated "dangerous
voltage" within the product's
enclosure that may be of
sufficient magnitude to
constitute a risk of electric
shock to persons.
&
This symbol is intended to alert
I
the user to the presence of
important operating and
maintenance (servicing)
·
instructions intheliterature
accompanying the appliance.
2
If you have any questions about this product,
you may call:
Sony Customer lnfonnation Center
1-800-222-S0NY
(7669)
The number below is for the FCC related matters
only.
Regulatory Information
Declaration of Conformity
Trade Name: SONY
Model No.: DSC-Tl
Responsible Party: Sony Electronics Inc.
Address: 680 Kinderkamack Road,
Oradell, NJ 07649 U.S.A.
Te1cphone No.: 201-930-6972
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
fol1owing two conditions: (1) This device
may not cause harmful interference, and
(2) this device must accept any interference
received, including interference that may
cause undesired operation.
Note:
Model DSC-Tl is to be used with USB cradle
Model UC-TA and AC Adaptor Model AC-
LM5.
CAUTION
You are cautioned that any changes or
modifications not expressly approvedin this
manual could void your authorityto operatethis
equipment.
Note:
This equipment has hcen tested and found to
comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment generates,
uses, and can radiate radio frequency energy and,
if not installed and used in accordance with the
instructions, may cause harmful interference to
radio communications. However, there is no
guarantee that interference wi II not occur in a
particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning
the equipment off and on, the user is encouraged
to try to COITectthe interference by one or more of
the following measures:
-
Reorient or relocate the receiving antenna.
-
Increase the separation between the
equipment and receiver.
-
Connect the equipment into an outlet on a
circuit dilferent from that to which the
receiver is connected.
-
Consult the dealer or an experienced radial
TV technician for help.
The shielded interface cable must be used with
the equipment in order to comply with the limits
for a digital device pursuant to Subpart B of Part
15 of FCC Rules.