Preferred Line And Preferred Line Timeout - Aastra 6757i User Manual

Additional Features

Preferred Line and Preferred Line Timeout

The 6757i has a feature called "preferred line" and "preferred line timeout". If you enable the preferred line parameter on
your phone, after a call ends (incoming or outgoing), the display switches back to the preferred line. Next time you go
off-hook to make another call, you pickup on the preferred line. You can enable the preferred line parameter using the
Aastra Web UI at the location, Basic Settings->Preferences->General. You can also set a preferred timeout parameter
that specifies the number of seconds it takes for the phone to switch back to the preferred line.
Note:
You can configure "Preferred Line" and "Preferred Line Timeout" using the Aastra Web UI only.
The following table provides the behavior of the preferred line focus feature with other features on the phone.
Phone Feature
call return
speed dial
conference
transfer
blf
park
voicemail
redial
dialing
caller id
factory default
Notes:
1. If you specify a value of "0" for the preferred line parameter, it disables the preferred line focus feature.
2. If you specify a value of "0" for the preferred line timeout parameter, the phone returns the line to the preferred line
immediately.
170
Preferred Line Behavior
The phone switches back to the focused line immediately after the call ends.
The line is already specified when the speed dial is created. The phone switches back immediately after the call
ends.
For incoming calls, the phone switches back immediately after the call ends.
For incoming or outgoing calls, the current behavior is that the same line used to transfer the call does not
change. For incoming calls, the phone switches back immediately after the call transfers.
The phone switches back immediately after the call ends.
The phone switches back immediately after the call ends.
The phone switches back immediately after the call ends.
The phone switches back immediately after the call ends.
For incomplete dialing on a non-preferred line, the focus does not change if some digits are entered.
If no digits are entered or digits were cleared, the focus changes to preferred line after the time out has passed
without activities.
If the "Switch UI Focus To Ringing Line" parameter is disabled, the User is able to see the Caller ID when the
phone switches the focus to the ringing line.
Factory default and recovery mode clears the "preferred line" and "preferred line timeout" parameters, and the
phone operates in a non-preferred line mode.
41-001385-05 REV03 – 07.2014