Launch And Quit Ecdis900 - Simrad Maris ECDIS900 Technical Manual

Launch and quit ECDIS900

To update the software contact Navico Technical support.
If a previous version of the ECDIS900 is installed on the hard
•
disk, the set-up program saves the Sensor_Monitor
configurations, installed charts, routes and tracks.
Once the ECDIS900 application installed on the hard disk,
•
several folders containing the application, utilities and data
have been created.
NOTE
ECDIS display is type approved device and should be used with
•
factory settings. Software does not require screen resolution
and colour mode, but it is strongly recommended to use
resolution no less than 1280 * 1024.
In case the Win 7 OS the Windows Classic Theme must be set. In
•
case of using another theme, some GUI colours could be
inconsistent.
In case of technical problems
M
ULTI HARDWARE
ECDIS900 has been approved with different PCs and monitors. ECDIS900 needs a proper
colour table to be used. During installation of the ECDIS900 software it is necessary to select
the targeted display.
REMARK
when Hatteland monitor are used the color table is automatically uploaded from
the monitor to the PC.
O
PERATIONAL LIMITS
Operational limits of ECDIS900 are listed
T
ESTS
On board regular tests are to be performed to check that all components of the system work
properly
IMPORTANT
All software, including ECDIS900, should run with
as Shell on MARIS computers.
The ECDIS900 runs under:
Windows XP
•
Windows 7
•
63
Launch and quite ECDIS900
or to order new charts please contact the Navico support.
here
L
AUNCH AND QUIT
as described below.
ECDIS900
Application Manager operating