Simrad Maris ECDIS900 Technical Manual page 31

Master and Slave modes
G
ENERAL SETTINGS
Send data to IP port specifies main output UDP port to which will be sent parameter
•
data and target tables (non-AIS)
Destination host specifies destination mode for this port. Smart broadcast means that
•
Sensor Monitor will broadcast data if there is network connection, otherwise it sends data
to 127.0.0.1.
ECDIS autopilot port specifies port for receiving of different ECDIS feedback (autopilot
•
data and so on). ECDIS always broadcasts these data if possible.
Check GPS quality controls "position quality protection". The position is marked as faulty
•
if there is no GPS quality indicator or if the quality is different from Autonomous or
differential. Important: AIS sensor does not send position quality indicator.
Assume quality if missing when ticked forces to assign good quality state to the position
•
when GPS quality indicator is missing but not present and invalid. This allows to use
position sources like AIS transponders
Socket time to live allows limiting number of hops between network routers that
•
packets might do. It is possible to disallow packets to be sent outside of certain subnets.
This feature is an alternative to multicast groups.
Network connection check specifies if it is necessary or not to check the network
•
connection periodically. If this mode is activated, Sensor Monitor will periodically check
the network connection.
31
Settings in EXPERT MODE