Simrad Maris ECDIS900 Technical Manual page 69

Troubleshooting
Monitoring
station: Warning
Serial ports. "GPS – DR alarm"
Serial cables in ECDIS900
Sensor output set In SMonitor GPS1
up. data not available
S_Monitor or faulty.
configurations Same for the
second GPS and
planning station
69
Bad connection
The ship's
with the GPS 1.
position is not
GPS 1 failure.
monitored on the
Bad selected data
chart.
format.
04,07,08.
If not reboot the
computer, enter
the set up and
change IRQ.
Run the recovery
CD.
Check the board
plug.
Replace the serial
board.
Check the serial
cable plugged in
the computer and
in the GPS.
Check the wiring
RS232 or 422 ...
(See technical
manual).
Open the terminal
window in
SMonitor and
check the
incoming data
format.
Select another
format (NMEA
or..) ij the
configuration
window of the
serial port
Check the output
configuration of
the GPS.
Click right button
in the GPS
indicator and
select GPS1 as
master.Check the
serial cable
plugged in the
computer and in
the GPS.
Check the wiring
RS232 or 422 ...
(See technical
manual).
Open the terminal