Connecting A Device With A Separate Video Output - Creative Video Blaster Digital VCR User Manual

V B D VCR U
I D E O L A S T E R I G I T A L

Connecting a Device with a Separate Video Output

You need the supplied adapter cable for this setup.
To connect a device that has separate audio and video outputs, follow these steps:
1. Connect the supplied S-Video to RCA adapter to the video input on the Digital VCR card.
Refer to area 2 in the diagram.
2. Connect an RCA cable from the video output of your device to the video input on the
adapter connected to the Digital VCR card in the step above.
3. Connect the audio outputs from your device to the audio inputs on the Digital VCR card.
You may need an adapter cable to connect the RCA audio outputs found on most consumer
electronics devices to the Digital VCR card.
To select the Video input signal type:
1. Quit the Digital VCR application.
2. Select Start >>> Programs >>>Creative >>> VB Digital VCR >>> Reconfigure Digital
VCR.
3. Select the 9LGHR ,QSXW page.
4. Click the &RPSRVLWH radio button.
5. Click the 6DYH 6HWWLQJs button.
6. Click the ([LW button.
The new settings will be available the next time the Digital VCR software is launched. To
watch the external video device, select channel  (zero) on the remote control. Do this by
pressing the number
U si n g Ext e rna l De vic es : C o nn e ct in g a De vi ce w it h a Se pa rat e Vid e o O u tp u t
' G
S E R S U I D E

button followed by the
(
button.
17(5
86