Storing The Machine - Hitachi ZAXIS 450LC-3 Operator's Manual

STORING THE MACHINE

1. Inspect the machine. Repair worn or damaged parts.
Install new parts if necessary.
2. Clean the primary air cleaner element.
3. Retract all hydraulic cylinders, if possible. If not, coat
exposed cylinder rods with grease.
4. Lubricate all grease points.
5. Park the tracks on long stable blocks.
6. Wash the machine.
7. Remove the batteries and store them in a dry protected
place after charging fully. If not removed, disconnect the
negative battery cable from the (−) terminal.
8. Add an antirust agent to the coolant. In cold weather,
add an antifreeze, or drain the coolant completely. Be
sure to attach a "No Water in Radiator" tag on a clearly
visible location if the system is drained.
9. Loosen the alternator belt and fan belt.
10. Paint necessary areas to prevent rust.
11. Store the machine in a dry, protected place. If stored
outside, cover with a waterproof cover.
12. If the machine is stored for a long time, operate hydraulic
functions for travel, swing and digging two to three
times for lubrication, at least once a month.
Be sure to check the coolant level and lubrication
conditions before operating.
Precautions for Disconnecting or Connecting
Batteries
In case the batteries are kept disconnected for more
than one month or when the batteries are reconnected,
contact your nearest Hitachi dealer. Resetting of the ICX
(Information Controller) may be required.
STORAGE
10-1