Avoid Heating Near Pressurized Fluid Lines; Avoid Applying Heat To Lines Containing Flammable Fluids; Remove Paint Before Welding Or Heating - Hitachi ZAXIS 450LC-3 Operator's Manual

Hydraulic
Hide thumbs Also See for ZAXIS 450LC-3:
Table of Contents

Advertisement

AVOID HEATING NEAR PRESSURIZED FLUID LINES

• Flammable spray can be generated by heating near
pressurized fluid lines, resulting in severe burns to yourself
and bystanders.
• Do no
heat by welding, soldering, or using a torch near
t
pressurized fluid lines or other flammable materials.
• Pressurized lines can be accidentally cut when heat goes
beyond the immediate flame area. Install temporary fire-
resistant guards to protect hoses or other materials before
engaging in welding, soldering, etc..
AVOID APPLYING HEAT TO LINES CONTAINING
FLAMMABLE FLUIDS
• Do not weld or flame cut pipes or tubes that contain
flammable fluids.
• Clean them thoroughly with nonflammable solvent before
welding or flame cutting them.

REMOVE PAINT BEFORE WELDING OR HEATING

• Hazardous fumes can be generated when paint is heated by
welding, soldering, or using a torch. If inhaled, these fumes
may cause sickness.
Avoid potentially toxic fumes and dust.
• Do all such work outside or in a well-ventilated area.
Dispose of paint and solvent properly.
• Remove paint before welding or heating:
1. If you sand or grind paint, avoid breathing the dust.
Wear an approved respirator.
2. If you use solvent or paint stripper, remove stripper with
soap and water before welding. Remove solvent or paint
stripper containers and other flammable material from
area. Allow fumes to disperse at least 15 minutes before
welding or heating.
SAFETY
510-E01B-0030
511-E01A-0029
S-28
SA-030
SA-029

Advertisement

Table of Contents
loading

This manual is also suitable for:

Zaxis 650lc-3Zaxis 850lc-3

Table of Contents