Code 11 Length Control; Code 11 Set Length 1 - Datalogic Heron HD3130 Product Reference Manual

Symbologies

Code 11 Length Control

This feature specifies either variable length decoding or fixed length decoding
for the Code 11 symbology.
Variable Length:
may be set.
Fixed Length:
DEFAULT
$CC1LC01
Code 11 Length Control = Fixed Length

Code 11 Set Length 1

This feature specifies one of the bar code lengths for
on page
page 169
Length includes the bar code's check and data characters.
The length can be set from 2 to 50 characters. See
for more detailed programming instructions.
Select Code 11 Set Length 1 Setting
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
Product Reference Guide
For variable length decoding, a minimum and maximum length
For fixed length decoding, two different lengths may be set.

169. Length 1 is the minimum label length if in
Mode, or the first fixed length if in
$CC1L1
04 = Length 1 is 4 Characters
DEFAULT
Enter/Exit Programming Mode
$CC1LC00
Code 11 Length Control = Variable Length
Code 11 Length Control
Fixed Length on page 169
"Set Length 1"
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from
the Alphanumeric characters in
pad
representing your desired character(s). End by
scanning the ENTER/EXIT bar code again.
CANCEL

Variable Length on
Mode.
on page 245
Appendix D, Key-
~
169