Select Audio Jingle For Transmit Error Sound - Datalogic Heron HD3130 Product Reference Manual

Reading Parameters

Select Audio Jingle for Transmit Error Sound

This parameter selects which preloaded Jingle to use to indicate a Transmit
Error sound.
After uploading up to fifteen (15) Jingles to the scanner using the Datalogic
Aladdin
(1-15) will be sounded when the scanner performs a good read.
$CAUAL
Select Audio Jingle on Tx Error event
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
DEFAULT
Product Reference Guide
"Audio Jingle Enable" on page 66 must be selected for this configuration
item to take effect.
NOTE
™
configuration utility, use this setting to designate which of the Jingles
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by two digits
from the Alphanumeric characters in
Keypad
representing the desired Jingle #. End by scan-
ning the ENTER/EXIT bar code again.
00 = Use built-in Transmit Error Sound indication
Enter/Exit Programming Mode
Appendix D,
~
CANCEL
71