RS-232/USB-COM Interfaces
Indicate Transmission Failure
This option enables/disables the scanner's ability to sound an error beep to
indicate a transmission failure while in ACK/NAK mode
$CR2TF01
Indicate Transmission Failure = Enable Indication
Disable Character
Specifies the value of the RS-232 host command used to disable the scanner.
ASCII characters or any hex value from 0 to 0xFF can be selected. See
Character"
$CR2DC
Select Disable Character Setting
Product Reference Guide
on page 224 for more detailed programming instructions.
Setting to previously defined characters such as XON, XOFF, or
host commands conflicts with normal operation of these char-
acters.
NOTE
0x44 = Disable Character is 'D'
DEFAULT
Enter/Exit Programming Mode
.
$CR2TF00
Indicate Transmission Failure = Disable Indication
DEFAULT
"Disable
33